To Next PageTo Next Page
Need help?Do you have a question about the Bosch GST 85 P and is the answer not in the manual?
General| Power Output | 350 W |
|---|---|
| Stroke Rate | 500 - 3100 spm |
| Stroke Height | 26 mm |
| Cutting Depth in Wood | 85 mm |
| Cutting Depth in Steel | 10 mm |
| Cutting Depth in Aluminium | 20 mm |
| Bevel Cut Angle | 45° |
| Stroke Length | 26 mm |
| Saw Blade Length | 100 mm |
| Cutting Depth at 90° | 85 mm |
| Sound Pressure Level | 88 dB(A) |
| Sound Power Level | 99 dB(A) |
The numbering of the machine elements refers to the illustration of the machine on the graphics page.
The machine is intended for making separating cuts and cut-outs in wood, plastic, metal, ceramic plates and rubber.
Read all instructions. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury.
Wear protective gloves when assembling the saw blade. Contact with the saw blade can lead to injuries.
To start the machine, press the On/Off switch 4 forward. To switch the machine off, press the On/Off switch 4 to the rear.
The required stroke rate can be preselected (also during operation) using the thumbwheel 2.
The contact protector 13 attached to the housing prevents unintentional contact with the saw blade.
The sawdust blower device leads an air jet to the saw blade. The air jet keeps sawdust from covering the cutting line.
The four pendulum action settings allow optimum adaptation of cutting speed, cutting capacity and cutting pattern to the material.
The base plate is originally equipped with a replaceable base-plate cover 21 made of plastic.
To avoid fraying of the surface, install the splinter guard 19 by pressing it into the base plate 8.
The machine can be plugged directly into the receptacle of a Bosch all-purpose vacuum cleaner with remote starting control.
The transparent cover guard 12 enables the collection of chips and sawdust.
With the combined circle cutter/parallel guide 23, circular cutouts or parallel cuts in materials of up to 30 mm thickness can be made.
Plunge cuts may only be applied to soft materials, such as wood, aerated concrete, gypsum plaster boards, etc.
For easier sawing in particularly tight locations, the rotatable top handle 1 can be removed.
Exploded views and information on spare parts can be found under: www.bosch-pt.com
