Do you have a question about the Bosch GST 80 PBE and is the answer not in the manual?
Brand | Bosch |
---|---|
Model | GST 80 PBE |
Category | Power Tool |
Language | English |
Read all safety warnings, instructions, illustrations and specifications provided with this power tool.
Keep work area clean and well lit. Cluttered or dark areas invite accidents.
Power tool plugs must match the outlet. Never modify the plug.
Hold the power tool by insulated gripping surfaces when performing an operation where the cutting accessory may contact hidden wiring.
When fitting or changing the saw blade, wear protective gloves. Blades are sharp and can become hot.
You will find an overview of recommended saw blades at the end of these operating instructions. Only use saw blades with single lug shank.
Set the pendulum action adjusting lever (6) to level III before inserting the saw blade (9).
The pendulum action can be adjusted using four different settings, allowing the cutting speed, cutting capacity and the cut itself to be optimally adapted.
The base plate (7) can be swivelled to the right or left to make mitre cuts up to 45°.
You can move the base plate (7) back for sawing close to edges.
The cutting line can be kept clear of chips using the airflow from the sawdust blower device.
Pay attention to the mains voltage. The voltage of the power source must match the voltage specified on the rating plate.
To switch on the power tool, press the on/off switch (2). To lock the on/off switch (2), press and hold it.
You can variably adjust the stroke rate of the power tool when it is on by pressing in the on/off switch (2) to varying extents.
Pull the plug out of the socket before carrying out any work on the power tool. Switch the power tool off immediately if the saw blade becomes blocked.
To ensure safe and efficient operation, always keep the power tool and the ventilation slots clean.
Our after-sales service can answer questions concerning product maintenance and repair, as well as spare parts.