Bosch GWS 24-230 JVX - Page 18

English | 19
Bosch Power Tools 1 609 92A 0B2 | (1.8.13)
Product Features
The numbering of the product features refers to the illustra-
tion of the machine on the graphics page.
1 Spindle lock button
2 Vibration damper
3 On/Off switch
4 Auxiliary handle (insulated gripping surface)
5 Grinder spindle
6 Protection guard for grinding
7 Encoding key
8 Clamping lever for protection guard
9 Screw for adjustment of protection guard
10 Mounting flange with O-ring
11 Grinding wheel*
12 Clamping nut
13 Quick-clamping nut *
14 Carbide grinding head*
15 Protection guard for cutting*
16 Cutting disc*
17 Hand guard**
18 Rubber sanding plate*
19 Sanding sheet*
20 Round nut*
21 Cup brush*
22 Cutting guide with dust extraction protection guard *
23 Diamond cutting disc*
24 Handle (insulated gripping surface)
*Accessories shown or described are not part of the standard de-
livery scope of the product. A complete overview of accessories
can be found in our accessories program.
Technical Data
Noise/Vibration Information
Measured sound values determined according to EN 60745.
Typically the A-weighted noise levels of the product are: Sound pressure level 93 dB(A); Sound power level 104 dB(A).
Uncertainty K=3 dB.
Wear hearing protection!
Angle Grinder GWS ... 24-230 JVX 24-230 JVX
Article number
3 601 ... H64 Z..
H64 5..
H64 U..
Rated power input W24002400
Output power
W16001600
Rated speed
min
-1
6500 6500
Grinding disc diameter, max.
mm 230 230
Thread of grinder spindle
M 14 M 14
Thread length (max.) of grinder spindle
mm 18 18
Restarting Protection
– 
Reduced starting current
 
Rotatable main handle
 
Run-on Brake
 
Weight according to EPTA-Procedure 01/2003
– with vibration-damping auxiliary handle
– with standard-auxiliary handle
kg
kg
6.5
6.4
6.6
6.5
Protection class
/II /II
The values given are valid for a nominal voltage [U] of 230 V. For different voltages and models for specific countries, these values can vary.
Only for power tools without reduced starting current: Starting cycles generate brief voltage drops. Interference with other equipment/machines may
occur in case of unfavourable mains system conditions. Malfunctions are not to be expected for system impedances below 0.25 ohm.
3 601 ... H64 Z.. H64 5.. H64 U..
Vibration total values a
h
(triax vector sum) and uncertainty K determined accord-
ing to EN 60745:
Surface grinding:
a
h
K
Disk sanding:
a
h
K
m/s
2
m/s
2
m/s
2
m/s
2
6.5
1.5
3.5
1.5
6.5
1.5
3.5
1.5
6.5
1.5
3.5
1.5
OBJ_BUCH-769-008.book Page 19 Thursday, August 1, 2013 9:59 AM