To Next PageTo Next Page
Need help?Do you have a question about the Bosch Professional GWS 2200-180 H and is the answer not in the manual?
General safety warnings applicable to grinding, sanding, wire brushing, and abrasive cutting operations.
Specifies the intended applications for the power tool, including cutting, roughing, brushing metal, stone, and sanding.
Details the numbered product features corresponding to the power tool diagram.
Instructions on positioning and securing the protective guard for grinding operations.
Guidelines for using the protective guard specifically for cutting bonded abrasives.
Details on fitting the extraction guard for cutting with a guide block.
Emphasis on the necessity of using the side handle for safe operation.
Instructions for fitting the hand guard when using sanding pads or brushes.
Guidelines for selecting and fitting grinding or cutting discs, including direction of rotation.
Information on fitting flap discs, noting the presence of an O-ring for hub flange.
Instructions for fitting the rubber sanding pad, including spacer discs and round nut.
Instructions on initial start-up, paying attention to mains voltage and tool marking.
Detailed steps for starting and stopping the power tool, including locking the switch.
Practical advice for operating the tool safely, including workpiece security and load management.
Guidance on performing rough grinding, including optimal angle and pressure.
Information on using flap discs for curved surfaces and profiles, noting benefits.
Instructions for cutting metal, emphasizing guard use, moderate feed, and avoiding tilting.
Advice for cutting stone, including dust extraction, mask use, and diamond disc selection.
Guidelines for keeping the tool clean, using dust extractors, and handling accessories.
Information on obtaining after-sales service, spare parts, and product advice.
General