Bosch GWS Professional 1000 - Technical Data; Declaration of Conformity

26 | English
1 609 929 W53 | (24.3.10) Bosch Power Tools
Technical Data
Declaration of Conformity
We declare under our sole responsibility that
the product described under “Technical Data” is
in conformity with the following standards or
standardization documents: EN 60745 accord-
ing to the provisions of the directives
2004/108/EC, 2006/42/EC.
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
05.03.2010
Assembly
Mounting the Protective Devices
f Before any work on the machine itself, pull
the mains plug.
Note: After breakage of the grinding disc during
operation or damage to the holding fixtures on
the protection guard/power tool, the machine
must promptly be sent to an after-sales service
agent for maintenance (for addresses, see sec-
tion „After-sales Service and Customer Assist-
ance“.
Angle Grinder GWS 1000
Professional
GWS 1000
Professional
GWS 1100
Professional
GWS 1400
Professional
Article number
3 601 H21 0..
3 601 H21 4..
3 601 H21 8.. 3 601 H22 0.. 3 601 H24 8..
Rated power input
W 1000 1000 1100 1400
Output power
W 630 630 660 820
Rated speed
min
-1
11000 11000 11000 11000
Grinding disc diameter, max.
mm 115 125 125 125
Thread of grinder spindle
M 14 M 14 M 14 M 14
Thread length (max.) of grinder
spindle
mm 22 22 22 22
Reduced starting current
– – z z
Constant electronic control
– – z z
Weight according to
EPTA-Procedure 01/2003
kg 2.1 2.1 2.0 2.2
Protection class
/II /II /II /II
The values given are valid for nominal voltages [U] of 230/240 V. For lower voltage and models for specific countries,
these values can vary.
Please observe the article number on the type plate of your machine. The trade names of the individual machines
may vary.
Dr. Egbert Schneider
Senior Vice President
Engineering
Dr. Eckerhard Strötgen
Head of Product
Certification
OBJ_BUCH-310-003.book Page 26 Wednesday, March 24, 2010 9:03 AM