Need help?Do you have a question about the Bosch GWS 6-100 and is the answer not in the manual?
Keep work area clean and well lit. Avoid explosive atmospheres. Keep children away from the tool.
Match plugs to outlets. Avoid body contact with grounded surfaces. Do not expose to rain. Do not abuse cord.
Stay alert. Use safety equipment. Avoid accidental starting. Remove adjusting keys. Dress properly.
Do not force the tool. Repair if switch is faulty. Disconnect from power before adjustments. Maintain tools.
Read all information. Wear protective glasses and hearing protection. Use additional safety equipment. Be aware of dust hazards.
Mount protection guard 5 for grinding/cutting discs. Adjust and clamp with screw 6. Closed side must face operator.
Mount auxiliary handle 2 on either side for all work. Ensure it is securely attached.
Mount hand guard 10 for sanding plate or brush. Fasten with auxiliary handle.
Observe disc dimensions. Hole diameter must fit flange 7. Do not use reducers. Mount clamping nut 9 with spanner.
Best results at 30-40° angle. Move back and forth. Avoid overheating and discolouration.
Do not press, jam, or oscillate. Use moderate feed. Do not reduce speed with sideward pressure.
To Next Page
General