Bosch HB 39 B Series - Page 18

en HomeConnect
18
13.3 Discarding changes to the basic
settings
▶
Touch the ⁠button.
a All changes are discarded and not saved.
14 HomeConnect
This appliance is network-capable. Connecting your ap-
pliance to a mobile device lets you control its functions
via the HomeConnect app, adjust its basic settings
and monitor its operating status.
The HomeConnect services are not available in every
country. The availability of the HomeConnect function
depends on the availability of HomeConnect services
in your country. You can find information about this at:
www.home-connect.com.
The HomeConnect app guides you through the entire
login process. Follow the instructions in the HomeCon-
nect app to configure the settings.
Tips
¡ Please consult the documents supplied by
HomeConnect.
¡ Please also follow the instructions in the HomeCon-
nect app.
Notes
¡ Please note the safety precautions in this instruction
manual and make sure that they are also observed
when operating the appliance via the HomeCon-
nect app.
→"Safety", Page2
¡ Operating the appliance on the appliance itself al-
ways takes priority. During this time it is not possible
to operate the appliance using the HomeConnect
app.
¡ In networked standby mode, the appliance requires
a maximum of2W.
14.1 Setting up HomeConnect
Requirements
¡ The appliance is connected to the power supply and
is switched on.
¡ You have a mobile device with a current version of
the iOS or Android operating system, e.g. a smart-
phone.
¡ The mobile device and the appliance are within
range of your home network's Wi-Fi signal.
1.
Download the HomeConnect app.
2.
Open the HomeConnect app and scan the follow-
ing QR code.
3.
Follow the instructions in the HomeConnect app.
14.2 HomeConnect Settings
You can adjust the settings and network settings for HomeConnect in the basic settings for your appliance.
The settings shown in the display depend on whether HomeConnect is set up and whether the appliance is connec-
ted to the Wi-Fi.
Basic setting Possible settings Explanation
Setting with the as-
sistant
- An assistant guides you through the set-up and settings of
HomeConnect.
Appliance info ⁠ - If you select the appliance information, the display shows in-
formation about the network or the appliance.
Wi-Fi On
Off
If Wi-Fi is activated, you can use HomeConnect.
In networked standby mode, the appliance requires max. 2W.
Disconnecting the
network
- If you disconnect from the network, the network information is
retained.
After switching on the appliance, it may take a few seconds
until the appliance has established the connection to the net-
work.
Connect to app
Connect to other app
- The setting starts the connection between the HomeConnect
app and the appliance.
Software update - The setting is only displayed if an update is available.