Why is my Bosch Kitchen Appliances not showing anything on the display and won't turn on?
If your Bosch Kitchen Appliances displays nothing and won't switch on, the issue is likely a lack of power supply. Check that the appliance is properly plugged into the mains.
What to do if SensorControl Plus on my Bosch Kitchen Appliances cannot be started?
If SensorControl Plus on your Bosch Kitchen Appliance cannot be started and shows “ADD INGREDIENTS” even after adding them, it means the ingredients were added before the scales were activated. Empty the bowl, reselect the program, and only add ingredients after the program is selected and the scales display “0 g” or “0.00 lb” (depending on setting) or “ADD INGREDIENTS”.
What to do if my laundry is caught in the door of my Bosch Washer/Dryer?
If laundry is caught in the door of your Bosch Washer/Dryer, remove any trapped laundry.
How to fix long drying times on my Bosch Washer/Dryer?
If your Bosch Washer/Dryer is taking too long to dry, it could be due to a few factors. If the ambient temperature is greater than 30 °C or there is insufficient air circulation at the appliance's installation location, ventilate the area. Also, if fluff has accumulated in the drum, run the Cottons 90°C programme without any laundry or detergent.
Why Bosch Washer/Dryer spin result is not satisfactory?
If the spin result of your Bosch Washer/Dryer isn't satisfactory and the laundry is too wet, it could be due to a blocked drain pipe or water outlet hose. Clean the drain pipe and the water outlet hose. Also, ensure that the drain pipe or water drain hose isn't caught or jammed. If the unbalanced load detection system has interrupted the spin cycle because the laundry is unevenly distributed, redistribute the laundry in the drum.
How to troubleshoot a Bosch Kitchen Appliance when nothing is shown on the display and the illuminated ring is off?
If nothing is shown on the display and the illuminated ring is off, it means the appliance has no power supply. Check the power supply by plugging the mains plug into the mains.
What to do if my Bosch Kitchen Appliance switches off during use?
Your Bosch Kitchen Appliance might be switching off during use due to several reasons: * Too much food being processed at once or for too long. To resolve this, turn the rotary switch to 'y', disconnect the mains plug, reduce the processing quantity, and allow the appliance to cool down to room temperature. * The swivel arm was opened. To fix this, turn the rotary switch to 'y', press the release button, and push the swivel arm down until it locks into place. * The bowl or bevel gear (accessory) has become loose. To correct this, turn the rotary switch to 'y', disconnect the mains plug, tighten the bowl by turning it until it stops, and tighten the bevel gear and close the locking lever completely.
Why does my Bosch Kitchen Appliance not show weight changes when adding ingredients?
Your Bosch Kitchen Appliance may not show weight changes because the quantity of added ingredients is less than 5 grams (0.01 lb). Add at least 5 grams (0.01 lb) for the scales to provide correct measurements.
What does 'ERROR ARM OPEN' mean on my Bosch Kitchen Appliances and how do I fix it?
If your Bosch Kitchen Appliance shows 'ERROR ARM OPEN', it means the swivel arm was opened. To fix this, turn the rotary switch to 'y', press the release button, and push the swivel arm down until it locks into place.
What does 'OVERLOAD or UNDERLOAD' mean when using SensorControl Plus on my Bosch Kitchen Appliances?
The message 'OVERLOAD or UNDERLOAD' when using SensorControl Plus on your Bosch Kitchen Appliance indicates that too much or too little of the ingredients was added for the selected program. Add ingredients according to the specified quantities.
To Next Page
General