Preparation
Before you Begin
Tools and Parts Needed
Parts Included
27" Appliances
General Information
• Phillips head screwdriver
• Measuring tape
• Drill with bit (1/8")
Phillips head screws (6)
Power Requirements The outlet must be properly grounded in accordance with all applicable codes.
Dimensions for 27" Wall-Mounted Units
251/2"
(648r _m)
24"
(610ram)
r_ 263/4,,
68°mm)-_'_ 2413/16,, (718mm)
"_ 27"
291/16" (686mm)
(738mm) rain. 43/4" (121ram)
J_o max. 313/8" (797mm)
237/8" (606ram)
_22" (559mm)
Single Oven 27"
It is good practice, when oven is
installed at the end of a cabinet run,
adjacent to a perpendicular wall or
cabinet door, to allow at least 1/4"
space between the side of the oven
and the wall/door.
For oven support, install 2x4's
extending front to back flush with the
bottom and the side of the opening.
The supporting base must be well
secured to the floor/cabinet and level.
Note: The conduit box must be
installed either above or below the
unit. If the conduit box is installed
below the unit, a 2" diameter hole or
space is required between the back
wall and the right rear of the 2x4
supports.
The cabinet base must be flat and
capable of supporting a weight of at
least 210 Ibs (95 kg).
English 3
To Next Page
Loading...
