Page 12
Attaching flue duct
Hidden surfaces may have sharp edges. Use caution
when reaching behind or under appliance.
1. Remove the protective foil from both ue ducts.
2. Push one ue duct into the other.
Notes
• To prevent scratches, lay paper over the edges of
the lower ue duct to protect the surface.
• For ducted operation, turn the upper ue duct so
that the ventilation slots point downward.
3. Remove the protective foil from the extractor hood.
4. Place ue ducts on the appliance.
5. Push the inner ue duct upwards and attach it to the
angle brackets on the left and right.
6. Screw the ue duct to the sides of the angle bracket
using two screws.
A Installation pipe
B Power connection
C Cable connector listed in UL
7. Fasten the lower part of the ue duct using two
screws.
8. Remove the protective paper from the lower ue duct.
9. Install metal-mesh grease lter.
Removing the appliance
1. Remove the metal-mesh grease lter.
2. Loosen the ue duct.
3. Disconnect the appliance from the power supply.
4. Loosen the exhaust air lines.
5. Loosen screws for fastening the appliance.
6. Remove the appliance.
To Previous Page
Loading...
