58300000194725 ARA EN B MAY 2016 Service Manual for Bosch 800 Series Gas Slide-in Ranges
Page 22 of 36
Copyright by BSH Home Appliances Corporation 1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614 800 944-2904
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
6. Remove screws securing the broil flame spreader/burner
assembly, and place assembly on protected work surface.
7. Remove the screws (and nuts) securing the igniter to the
mounting bracket.
8. Test and/or replace the igniter.
9. Reassemble, restore power and gas supply, and test
operation.
6.6.2 Replacing the Broil Burner
1. Follow steps 1-7 in Replacing the Broil Igniter section.
2. Remove the nut, washers and screw securing the broil burner
tube to the flame spreader.
Figure 26 Broil HSI wires are visible after removing rear housing cover
Figure 27 Broil flame spreader/burner assembly with HSI
Figure 29 Broil flame spreader/burner assembly with HSI
To Next Page
Loading...
