58300000194725 ARA EN B MAY 2016 Service Manual for Bosch 800 Series Gas Slide-in Ranges
Page 23 of 36
Copyright by BSH Home Appliances Corporation 1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614 800 944-2904
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
3. Attach the igniter to the new burner and install.
4. Reassemble, restore power and gas supply, and test
operation.
6.6.3 Replacing the Bake Igniter
1. Remove power to the range and turn off the gas supply.
2. Remove oven door and racks.
3. Remove two thumb screws securing the bake chamber cover.
4. Remove two screws securing the front bake chamber trim
piece, and the third (center) screw securing the front of the
bake burner to the chamber.
5. Remove bake chamber cover from cavity and set aside.
6. Carefully slide the range out of the cutout to gain access to the
igniter wires in the rear of the unit.
7. Remove the rear housing panel.
8. Disconnect the bake HSI wires.
9. From inside the bake chamber, remove the screws/nuts
securing the HSI to the mounting bracket.
10. Test and/or replace the igniter.
11. Reassemble, restore power and gas supply, and test
operation.
6.6.4 Replacing the Bake Burner
1. Follow steps 1-8 in Replacing the Bake Igniter section.
2. In the rear of the unit, remove the four screws from the lower
bracket beneath the regulator and dual valve so that the bake
burner assembly will float.
3. Remove one screw from the bracket with cutouts that surround
the tubing, and remove the bracket.
Figure 30 Remove screws from bracket beneath regulator
Figure 31 Remove bracket surrounding burner and tubing
To Next Page
Loading...
