Bosch Indego l Indego 800

Questions and Answers

W
Wesley HamptonJul 31, 2025
What to do if Bosch Indego l Indego 800 machine fails to operate?
- M
  Melissa ParkerJul 31, 2025
  If your Bosch Lawn and Garden Equipment fails to operate, consider these potential causes and solutions: First, check underneath the garden product for any clogging and clear it out, wearing protective gloves. If there's no clogging, ensure the battery is fully charged by replacing the garden product in the docking station. If the grass is too long, increase the height of cut. Also, check if the battery is too hot or cold, and allow it to cool or warm. Finally, make sure the isolator key is correctly and fully inserted.
A
Andrew MillerAug 4, 2025
Why does my Bosch Indego l Indego 800 Lawn and Garden Equipment leave a ragged finish?
- P
  Peter TerryAug 4, 2025
  If your Bosch Lawn and Garden Equipment is leaving a ragged finish, it could be due to a few reasons. The height of cut might be too low, so try increasing it. Another possibility is that the cutting blade is blunt, in which case you should replace it. Also, check underneath the garden product for any clogging and clear it out as necessary, always wearing protective gloves.
T
Travis SmithAug 8, 2025
Why is my Bosch Indego l Indego 800 Lawn and Garden Equipment leaving areas uncut?
- S
  smithmelissaAug 8, 2025
  If your Bosch Lawn and Garden Equipment is leaving areas uncut, it could be due to several factors. First, the time slot might not be long enough for the garden size, so increase the mowing time slot. If the distance between obstacles surrounded by the perimeter wire is less than 1 m, increase the distance between the perimeter wire. For rough lawn conditions, increase or decrease cutting lane proximity from 'mow settings'.
M
michaelmaldonadoAug 12, 2025
What to do if Bosch Indego l Indego 800 Lawn and Garden Equipment motor starts and stops immediately?
- A
  amy18Aug 12, 2025
  If the motor of your Bosch Lawn and Garden Equipment starts and stops immediately, try these solutions: Ensure the battery is fully charged by placing the garden product in the docking station. Check that the isolator key is correctly and fully inserted. Also, the battery might be too hot or too cold; allow it to cool or warm. Finally, increase the height of cut.
A
Amy BrennanAug 17, 2025
Why is my Bosch Lawn and Garden Equipment making excessive vibrations or noise?
- W
  watsonlisaAug 17, 2025
  If your Bosch Lawn and Garden Equipment is experiencing excessive vibrations or noise, check if the blade nut or bolt is loose and tighten it. If that's not the issue, the cutting blade might be damaged and need replacement.
N
normantracyAug 21, 2025
What to do if Bosch Lawn and Garden Equipment is unable to dock?
- H
  Henry HessAug 21, 2025
  If your Bosch Lawn and Garden Equipment is unable to dock, check the perimeter wire and align it correctly. Also, ensure there is adequate distance (approximately 1 m) between your perimeter wire and any source of interference.
A
Angela WarnerAug 26, 2025
Why is the LED on my Bosch Indego l Indego 800 docking station flashing?
- R
  Richard DavidsonAug 26, 2025
  If the LED on your Bosch Lawn and Garden Equipment docking station is flashing, the perimeter wire might be broken, too long, or too short. Check that the perimeter wire is not broken and is between 20 and 450 meters in length. Then, switch off and on the power supply.