en
18
Eliminating minor faults yourself
Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following
information.
Customer service will charge you for advice – even if the appliance is still under
guarantee!
Fault Possible cause Remedial action
Temperature differs greatly
from the set value.
In some cases it is adequate to switch off
the appliance for 5 minutes.
If the temperature is too high wait a few hours
and check whether the temperature has
approached the set value.
If the temperature is too low check
the temperature again the next day.
Appliance has no
refrigeration capacity.
The light does not work.
The display does not
illuminate.
Power failure. Check whether the power is on.
The fuse has been switched
off.
Check the fuse.
The mains plug has not been
inserted properly.
Check whether the mains plug is secure.
Warning signal is emitted. Appliance is open. Close the appliance.
The temperature display
flashes.Fig. $/1
Fault - the freezer
compartment is too warm.
Frozen food is at risk.
To stop the temperature display flashing, press
temperature setting button. Press Fig. $/3.
The temperature display will also stop flashing
when the freezer section is cold enough again.
Ventilation openings are
covered up.
Ensure that there is adequate ventilation.
Too much food was placed in
the freezer at once.
Do not exceed the freezing capacity.
The temperature in the
freezer section is too warm.
Appliance opened
frequently.
Do not open the appliance unnecessarily.
The ventilation openings
have been covered.
Remove obstructions.
Large quantities of fresh
food are being frozen.
Do not exceed the freezing capacity.
To Next Page
Loading...
