Bosch KGN Series - Getting to Know Your Appliance; Control Panel

NL
watch the
ambient temperature
and the aeration
Connect device
After installing the device, you must wait at
least 1 hour before using the device.
During transport, the oil from the
compressor may enter the refrigeration
system.
Ambient temperature
The device is designed for a specific climate
class. Depending on the climate class, the
device can be used at the following ambient
temperatures.
Before using the appliance for the first
time, clean the interior of the appliance (see
chapter „Cleaning
the device").
The climate class can be
found on the type plate, fig. +.
Electrical connection
Climate class Permissible
ambient temperature
The mains socket must be close to the
device and easily accessible even after
setting up the device.
SN
N
ST
t
+ 10 °C to 32 °C
+ 16 °C to 32 °C
+ 16 °C to 38 °C
+ 16 °C to 43 °C
m Warning
Danger of electric shock!
Note
If the connecting cable is not long enough, do
not under any circumstances use
multiple outlets or extension cords.
Instead, contact customer service for
alternative solutions.
The device is fully functional within the
indoor temperature limits of the indicated
climate class. When a device of climate
class SN is used at a lower indoor
temperature,
damage to the device is excluded up to a
temperature of +5 °C.
The device complies with protection class I.
Connect the device to a
installed 220–240 V/50 Hz AC outlet with
ground wire. The socket must be protected
with a 10 A to 16 A fuse.
Aeration
Fig. $
The air at the rear wall and the side walls of
the appliance is heated. The heated air
must be able to be discharged without
hindrance. Otherwise, the chiller has to
perform more, increasing energy
consumption.
The ventilation openings must therefore
never be covered!
For appliances that are used in non-
European countries, check whether the
connection voltage and the type of current
correspond to the values of your
electricity network. You will find this
information on the type plate, fig. +.
73