en
31
Interior fittings
All variable parts of the appliance
can be taken out for cleaning.
Take out glass shelves
Pull the glass shelves forwards and take
out.
Removing the container
Fig. 4
Pull out the container all the way, lift at
the front and remove.
Light (LED)
Your appliance features a maintenance-
free LED light.
These lights may be repaired
by customer service or authorised
technicians only.
Tips for saving energy
■ Install the appliance in a dry, well
ventilated room! The appliance should
not be installed in direct sunlight
or near a heat source (e.g. radiator,
cooker).
If required, use an insulating plate.
■ Allow warm food and drinks to cool
down before placing in the appliance!
■ When thawing frozen products, place
them in the refrigerator. Use
the coldness of the frozen food
to cool food.
■ Open the appliance as briefly
as possible.
■ Occasionally clean the rear
of the appliance to prevent an
increased power consumption.
■ If available: Fit wall spacers to obtain
the indicated energy rating of the
appliance (see Installation
instructions). A reduced wall gap will
not restrict the function of the
appliance. The energy rating may then
change slightly. The gap of 75 mm
must not be exceeded.
To Next Page
Loading...
