Bosch KGN56 Series - Operating Tips; Switching off the Appliance; Setting the Temperature

en operation
18
flashes and the status display
lights up red because the freezer
compartment is still too warm.
2. Switch off the warning tone using
.
a ( ⁠) and the status
display go out as soon as the set
temperature has been reached.
3. Set the required temperature.
→Page18
7.2 Operating tips
¡ Once you have switched on the
appliance, the set temperature is
only reached after several hours.
Do not put any food in the appli-
ance until the set temperature has
been reached.
¡ The front panels of the housing are
temporarily heated slightly. This
prevents condensation in the area
of the door seal.
¡ When you close the door, a va-
cuum may be created. The door is
then difficult to open again. Wait a
moment until the vacuum is offset.
7.3 Switching off the appli-
ance
▶ Press and hold for tenseconds.
7.4 Setting the temperature
Setting the refrigerator
compartment temperature
1. Select the refrigerator compart-
ment using .
2. Press / repeatedly until the
temperature display (refrigerator
compartment) shows the required
temperature.
To reach the set temperature, slide
the temperature controller for the
storage container to a position that
is one third from the bottom.
→Page18
The recommended temperature in
the refrigerator compartment is
4°C.
Setting the storage container
temperature
1. To reduce the temperature, slide
the temperature controller in the
direction.
2. To increase the temperature, slide
the temperature controller in the
direction.
Setting the freezer compartment
temperature
1. Select the freezer compartment
with .
2. Press / repeatedly until the
temperature display (freezer com-
partment) shows the required tem-
perature.
The recommended temperature in
the freezer compartment is
−18°C.