Bosch MultiTalent 3 Plus - Page 29

29
en
Tool Speed Time Recipes / Ingredients / Processing
M Honey and hazel nut spread (CNCM12C)
– 20 g hazelnuts
– 80 g blossom honey (room temperature)
 Put the nuts in the universal cutter jug and cut with the blender/
cutting blade for 5 seconds on setting M.
 Remove the universal cutter jug, turn it over and take out the
blade insert.
 Add the honey. Close the universal cutter jug again with the
blade and put on the base unit.
 Wait until all the honey has run down over the blade. Then mix
everything for 5 seconds on setting M.
Fig. F shows guide values for the maximum quantities and processing times when
working with the universal cutter jug and the blade inserts.
Printed on 100% recycled paper
Recipes / Ingredients / Processing