Bosch Nexxt 300 - During Washing; Add a garment; Interrupting the program

300/DLX/500 Series
Start Bleach Rinse Heavy
Pause plus duty
0 0 0 0
0 ©
Options
500 Plus Series
Stad ECO Rinse Heavy
Pause plus duty
@ @ @ @
Cl If necessary, press the button(s) for
additional option(s).
The indicator light of the selected
button is lit (red).
D If an incorrect combination was
inadvertently selected, the
indicator light of the selected
button is turned off.
C_
If necessary, change the spin
speed with the Spin selection
button until the the desired spin
speed indicator light is lit.
Each press of the Delay start button
increases the delay start time by one
hour.
C_
If necessary, change the Start
time. Press the Delay Start button
until the desired Start time is
displayed.
..... "- @Sp!#
8_tn De_ay O O_O_k_k_
S_t_m s_rt
Cl Press the Start/Pause button.
The indicator light is lit (red).
Display shows the run time of the
selected program. The program
starts.
D Each program step is indicated by
the indicator lights under the
display.
During Washing
D Due to the highly engineered
suspension of this appliance, it
may experience a shudder or
shake when progressing from
lower to higher spin speeds.
This behavior is normal due to
shifting of the drum system and
should not cause concern.
Changing a program
CI Turn the program selector to Off.
CI Turn the program selector to a
newly selected program.
The Start/Pause indicator light
flashes.
CI If required, change the settings;
see from Page 19.
CI Pressthe Start/Pause button.
The program starts.
The indicator light is lit.
Add a garment /
Interrupting the program
You can put laundry in the drum after
washing begins, take laundry out of the
drum early or interrupt the program at
any time.
D It is not recommended to add
laundry after the washing phase is
complete.
D You can add or reduce laundry as
long as the Start/Pause indicator
light flashes (red).
CI Pressthe Start/Pause button.
The Start/Pause indicator light
flashes.
CI Open the door.
CI Place/remove the laundry.
CI Close the door.
CI Pressthe Start/Pause button.
The program continues.
The indicator light is lit (red).
%
%
When the Start/Pause indicator
light is lit (red), the program can be
interrupted, however the door
cannot be opened for safety
reasons (water level, temperature
or speed too high).
If the spin speed is too high, the
Start/Pause indicator light is lit
(red). Laundry can be added in
"Pause" mode when the drum is at
a standstill.
Canceling an active
program
If you would like to terminate a program
and remove the laundry:
D If a program is interrupted at a high
temperature, leave the laundry to
cool down until the glass is cool to
touch.
CI Turn the program selector to Off.
CI Turn the program selector to Drain
or Spin. (Does not apply to 500
Plus Series).
%
C_
C_
C_
C_
%
%
For Spin, select the desired spin
speed (but not no final spin).
Press the Start/Pause button.
Wait until this program ends.
Open the door.
Unload the laundry.
If a program is interrupted at a high
temperature, the door may remain
locked until the appliance has
cooled down.
If the program is terminated by
switching off the appliance, the
door may remain locked.
21