Electrical Connection
Power cord must be connected
by a qualified technician or a
licensed electrician only.
Connect to individual Branch
Circuit.
Do not use an adapter.
Do not use an extension cord.
Do not remove ground prong.
For CANADA
Your dryer comes with a power supply
cord, CSA listed in Canada.
The Bosch dryer requires a 4-wire
receptacle.
When installing the receptacle for the
dryer cord, ensure that the power
supply cord is accessible when the
dryer is in the installed position.
The power cord should only be
replaced by a qualified technician or
licensed electrician. If you must replace
the power cord that was originally
supplied with your appliance, the
power cord must meet the following
requirement:
- 4-wire only
- UL and CSA listed
- 208 - 240 volt rated (minimum)
- 30 amps
- Type SRDT
- Five feet long (minimum)
Refer to page 39 for 4-wire installation
instructions.
Grounding instruction
This appliance must be grounded. In
the event of a malfunction or
breakdown, grounding will reduce the
risk of electric shock by providing a
path of least resistance for the electric
current.
Additional grounding procedure
- Never ground the dryer to plastic
plumbing lines, gas lines or water
pipes.
10
To Next Page
Loading...
Need help?
General
