English - 1
1 On/Off switch
2 Lock-on button for On/Off switch
3 Dust box (micro filtersystem)
4 Thread
5 Adjustment screw
6 Belt speed thumbwheel (PBS 7 AE)
7 Recess for screw clamp
8 Holder for dust box
9 Outlet piece
10 Latching lever
11 Filter element (micro filtersystem)
12 Clamping lever
13 Access clip
14 Parallel and angle guide*
15 Screw clamp*
16 Base unit (PBS 7 AE SET)
* Not all of the accessories illustrated or described are
included as standard delivery.
Measured values determined according to
EN 50 144.
Typically the A-weighted noise levels of the prod-
uct are: sound pressure level: 89 dB (A); sound
power level: 102 dB (A).
Wear ear protection!
The typical hand/arm vibration is below 2.5 m/s
2
.
Working safely with this ma-
chine is possible only when the
operating and safety information
are read completely and the in-
structions contained therein are
strictly followed. In addition, the
general safety notes in the en-
closed booklet must be ob-
served. Before using for the first
time, ask for a practical demon-
stration.
■ Wear protective goggles, ear protection and a
dust protection mask.
■ Wear protective gloves.
■ For long hair, wear hair protection. Work only
with closely fitting clothes.
■ If the mains cable is damaged or cut through
while working, do not touch the cable but im-
mediately pull the mains plug. Never use the
machine with a damaged cable.
■ Connect machines that are used in the open
via a residual current device (RCD) with an ac-
tuating current of 30 mA maximum. Use only
extension cables that are approved for outdoor
use.
■ Always direct the cable to the rear away from
the machine.
■ Insert the mains plug only when the machine is
switched off.
■ Apply the machine to the workpiece only when
switched on. Switch off the machine only after
it has been lifted from the workpiece.
■ Always switch the machine off and wait until it
has come to a standstill before placing it down.
Tool Specifications
Belt sander PBS 7 A PBS 7 AE
Order number 0 603 391 0.. 0 603 391 7..
Rated power [W] 600 600
Output power [W] 300 300
No-load belt speed [m/min] 250 170 – 250
Length of sander belt [mm] 457 457
Width of sander belt [mm] 75 75
Belt speed preselection – •
Connection for integrated dust extraction • •
Weight (without accessories) approx. [kg] 2.4 2.4
Protection class / II / II
Please observe the order number of your machine. The trade names of the individual machines may vary.
Machine Elements
Noise/Vibration Information
For Your Safety
PBS 7 A/AE-Buch Seite 1 Montag, 6. September 2004 9:09 09
9 • 2 610 391 096 • TMS • 04.02.02
To Next Page
Loading...
