Bosch PIV975DC1E - Accessing and Configuring Settings; Discarding Changes; Cookware Test; Performing the Test

Cookware test en
13
Display Setting Value
⁠ Signal tones – Confirmation and fault signals are switched off.
– Only the fault signal is switched on.
– Only the confirmation signal is switched on.
– All signal tones are switched on
1
.
⁠ Energy consumption display
Shows the total energy consumption
between switching the hob on and off in
kWh.
The accuracy of the display depends on vari-
ous factors such as the voltage quality of the
power supply.
– Switched off.
1
– Switched on.
⁠ Automatic switch-off of the cooking zones. ⁠ – switched off.
1
⁠ ⁠- ⁠ - minutes until the appliance switches off auto-
matically.
⁠ Duration of the timer end signal tone – 10seconds
1
– 30seconds
- 1 minute
⁠ Power limitation
Enables the total power of the hob to be lim-
ited, if necessary, based on the conditions of
your electrical installation. The available set-
tings depend on the maximum power of the
hob (see rating plate). If the function is active
and the hob has reached the set power limit,
is displayed and you cannot select a higher
power level.
– Switched off. Maximum power of the hob
1
.
- 1000 W. Lowest power setting.
⁠. - 1500 W.
...
- 3000 W. Recommended for 13 A
⁠. - 3500 W. Recommended for 16 A.
- 4000 W.
⁠. - 4500 W. Recommended for 20 A.
...
- Maximum power of the hob.
⁠ ⁠ Cookware test
You can use this function to test the quality
of the cookware.
- Not suitable.
- Not optimal.
- Suitable.
⁠ Restoring factory settings - Individual settings
1
.
- Factory settings.
1
Factory setting
16.2 To go to the basic settings
Requirement:The hob must be switched off.
1.
To switch on the hob, touch ⁠.
2.
Within the next 10 seconds, press and hold for 4
seconds.
Product information Display
Directory for the technical after-sales
service (TK)
⁠
Production number
Production number 1 ⁠ ⁠.
Production number 2 ⁠.
a The first four displays provide the product informa-
tion. To call up the individual displays, touch the
control panel.
3.
Touch to access the basic settings.
a ⁠ and light up as a presetting.
4.
Touch repeatedly until the desired setting ap-
pears.
5.
Select the required setting in the settings area.
6.
Touch and hold for 4seconds.
a The settings are saved.
16.3 Discarding changes to the basic
settings
▶
Touch ⁠.
a All changes are discarded and not saved.
Cookware test
17 Cookware test
The quality of the cookware has a major influence on
the speed and the result of the cooking process.
You can use this function to test the quality of the cook-
ware.
Before the test, ensure that the size of the cookware
base corresponds to the size of the cooking zone be-
ing used.
Access is via the basic settings. →Page12