Installation and connection en
49
Transporting
Empty the dishwasher and secure loose
parts.
Drain the appliance according to the
following steps:
1. Turn on water supply.
2. Switch on ON/OFF switch (.
3. Select programme with the highest
temperature.
The estimated programme duration
appears in the display window @.
4. Press START button X.
Programme sequence starts.
5. After about 4 minutes, press and
hold the START button X for about
3 seconds.
The value ‹‹h:‹‚m appears in the
display window @. The
programme duration is about
1 minute. The value ‹‹h:‹‹m
appears in the display window @.
6. Switch off ON/OFF switch (.
7. Turn off water supply, disconnect
supply hose and drain water.
Note: Always transport the dishwasher
upright. This prevents residual water
from getting into the machine’s controls
and causing the programme sequence
to malfunction.
Protection against frost
Pr ot ec t i on agai ns t frost (Empt y i ng the appl i anc e)
If the appliance is in a room where
there is a risk of frost (e.g. holiday
home), empty the appliance completely
(see Transportation).
6XEMHFWWRFKDQ
HV
To Next Page
Loading...
Need help?
General
