14 | English 2 609 000 229 • 14.5.07
Assembly
Changing the Tool
f Before any work on the machine itself, pull
the mains plug.
f When mounting the saw blade, wear protec-
tive gloves. Danger of injury when touching the
saw blade.
Selecting the Application Tool/Accessory
Accessory Material Application
BIM segment saw
blade
Wooden materials,
plastic, non-ferrous
metals
Separating and plunge cuts; also for sawing
close to edges, in corners and hard to reach
areas;
Example: shortening already installed bottom
rails or door hinges, plunge cuts for adjusting
floor panels
HCS plunge cut saw
blade, wood
Wooden materials,
plastic, gypsum and
other soft materials
Separating and deep plunge cuts; also for
sawing close to edges, in corners and hard to
reach areas;
Example: Sawing off water pipes (PVC) or
cable ducts flush against walls, floors or ceil-
ings
Base plate for sand-
ing, series Delta
93 mm
Depends on sanding
sheet
Sanding surfaces close to edges, in corners or
hard to reach areas;
Depending on the sanding sheet for, e.g.,
sanding wood, paint, varnish, stone, glass
HCS plunge cut saw
blades, wood*
Wooden materials,
plastic, gypsum and
other soft materials
Smaller separating and plunge cuts;
Example: Cut-outs in furniture for cable con-
nections
BIM plunge cut saw
blades, metal*
Metal (e.g., nails,
screws, small profiles),
non-ferrous metals
Smaller separating and plunge cuts;
Example: Shortening narrow profiles, cutting
fastening elements such as staples
HM-Riff segment saw
blade*
Grouting joints, soft wall
tiles, glass-fibre rein-
forces plastic and other
abrasive materials
Cutting and separating close to edges, in cor-
ners or hard to reach areas;
Example: Removing grouting joints between
wall tiles for repair work, cutting openings in
tiles, gypsum boards or plastic
* Optional accessory; for the complete accessories please see Bosch accessory programme.
OBJ_BUCH-345-003.book Page 14 Monday, May 14, 2007 4:11 PM
To Next Page
Loading...
