English | 152 609 000 229 • 14.5.07
Mounting/Replacing the Application Tool/
Accessory
Mount the application tool/accessory (e.g. plunge cut
saw blade 7) in such a way on the tool holder 6 that the
openings of the tool engage into the cams of the tool
holder.
For a safe and fatigue-free working position it is possi-
ble to position the application tools/accessories in any
snap-in positions on the tool holder. Position the tool in
such a way that the depressed centre points down-
wards (marking on the tool is readable from above, see
figure on the graphics page).
Use the screw 8 to fasten the application tool/acces-
sory. Tightly fasten the screw 8 with the allen key 9.
f Check the tight seating of the application tool/
accessory. Incorrect or not securely fastened appli-
cation tools/accessories can come loose during
operation and pose a hazard.
For removing the application tool/accessory loosen the
screw 8 with the allen key 9 and remove the tool.
Mounting/Replacing a Sanding Sheet on the
Sanding Plate
The sanding plate 10 is fitted with Velcro backing for
quick and easy fastening of sanding sheets with Velcro
adhesion.
Before attaching the sanding sheet 11, free the Velcro
backing of the sanding plate 10 from any debris by tap-
ping against it in order to enable optimum adhesion.
Position the sanding sheet 11 flush alongside one edge
of the sanding plate 10, then lay the sanding sheet onto
the sanding plate and press it against it with a light turn-
ing motion in clockwise direction.
To ensure optimum dust extraction, pay attention that
the punched holes in the sanding sheet match with the
holes in the sanding plate.
To remove the sanding sheet 11, grasp it at one of the
tips and pull it off from the sanding plate 10.
You can use all sanding sheets, fleece pads/polishing
cloth pads of the Delta 93 mm series of Bosch acces-
sory program.
Sanding accessories, such as fleece pads/polishing
cloth pads, are attached to the sanding plate in the
same manner.
Selecting the Sanding Sheet
Depending on the material to be worked and the required rate of material removal, different sanding sheets are
available:
Material Application Grain size
– All wooden materials (e.g.,
hardwood, softwood, chip-
board, building board)
– Metal materials
For coarse-sanding, e.g. of rough, unplaned
beams and boards
coarse 40
60
For face sanding and planing small irregularities medium 80
100
120
For finish and fine sanding of wood fine 180
240
320
400
–Paint
–Varnish
– Filling compound
– Filler
For sanding off paint coarse 40
60
For sanding primer (e.g., for removing brush
dashes, drops of paint and paint run)
medium 80
100
120
For final sanding of primers before coating fine 180
240
320
OBJ_BUCH-345-003.book Page 15 Monday, May 14, 2007 4:11 PM
To Next Page
Loading...
