Bosch PMF 350 CES - Page 8

18 | English
Application tool PMF 350 CES Application tool PMF 350 CES
The following table shows examples of application tools. You can find additional application tools in Bosch’s extensive range of
accessories.
Application tool Material Application
Bi-metal segment
saw blade
Wood-based materials,
plastic, non-ferrous
metals
Separating cuts and plunge saw cuts;
including sawing close to edges, in corners and in difficult-
to-reach areas;
example: Shortening skirting boards that are already in-
stalled or door frames, plunge cuts when adapting floor
panels
Sanding plate for
Delta series 93mm
sanding sheets
Depends on the sanding
sheet
Sanding surfaces at edges, in corners or in difficult-to-
reach areas;
depending on the sanding sheet, e.g. for sanding wood,
paint, varnish, stone;
fleeces for cleaning and for texturing wood, removing rust
from metal and for keying varnish, polishing felt for pre-
polishing
Profile sander Wood, pipes/profiles,
paint, varnish, filler, metal
Convenient and efficient sanding of profiles up to a dia-
meter of 55mm;
red sanding sheets for sanding wood, pipes/profiles, var-
nish, filler and metal
Bi-metal plunge cut
saw blade for wood
and metal
Softwood, soft plastics,
plasterboard, thin-walled
aluminium profiles and
non-ferrous metal pro-
files, thin sheet metal,
non-hardened nails and
screws
Small separating cuts and plunge cuts;
example: Cutting a recess for sockets, cutting a copper
pipe so that it is flush with a surface, making plunge cuts in
plasterboard
Delicate adaptation work in wood;
example: Sawing recesses for locks and fittings
HCS plunge cut
saw blade for wood
Wood-based materials,
soft plastics
Separating cuts and plunge saw cuts;
including sawing close to edges, in corners and in difficult-
to-reach areas;
example: Thin plunge cut in solid wood for installing a
ventilation grille
Bi-metal plunge cut
saw blade, hard-
wood
Hardwood, laminated
boards
Plunge cuts in laminated boards or hardwood;
example: Installation of skylights
TC plunge cut saw
blade, metal
Metal, extremely abrasive
materials, fibreglass, plas-
terboard, cement-bonded
fibreboard
Plunge cuts in extremely abrasive materials or metal;
example: Cutting kitchen front covers, easy cutting
through hardened screws, nails and stainless steel
Bi-metal plunge cut
saw blade for wood
and metal
Softwood, hardwood,
veneered boards, plastic-
coated boards, non-
hardened nails and
screws
Plunge cuts in laminated boards or hardwood;
example: Shortening door frames, recesses for a shelf
TC-Riff segment
saw blade
Cement joints, soft wall
tiles, fibreglass-reinforced
plastics, porous concrete
Making cuts near edges, in corners or in difficult-to-reach
areas;
example: Removing joints between wall tiles for improve-
ment work, cutting recesses in tiles, plasterboard or
plastics
1 609 92A 84H | (08.07.2022) Bosch Power Tools