Need help?Do you have a question about the Bosch PRAESENSA PRAMPS3 and is the answer not in the manual?
General| Brand | Bosch |
|---|---|
| Model | PRAESENSA PRAMPS3 |
| Category | Security System |
| Language | English |
Essential safety guidelines and warnings for installation and operation.
Details key features like IP-infrastructure, power utilization, and system availability.
Discusses network topology, security, speed, and bandwidth for PRAESENSA systems.
Guides on choosing appropriate amplifiers based on load and zone requirements.
Provides methods for calculating required battery capacity for system backup.
Step-by-step guide for establishing network connection to the system controller.
Describes different network topologies like star, tree, and ring for device connectivity.
Information on device status indicators and procedures for factory reset.
Guidance on connecting the system controller to the network and other devices.
Mandatory safety ground connection for amplifier chassis and fault detection.
Instructions for connecting power supply to the amplifier, including redundancy.
Describes amplifier output channels and loudspeaker connection topologies.
Lists intended use for PA/VA systems and advanced features.
Introduction to compact DIN-rail mounted power supplies for PRAESENSA systems.
Details mains power supply, protections, and output specifications.
Addresses issues where devices do not respond, potentially due to RSTP.
Covers causes like incorrect PSK, firmware mismatch, or hop count issues.
Steps for performing fault analysis and replacing parts.
Procedures for replacing system controller, amplifiers, and power supplies.
Overview of compliance requirements for EN 54-16 and EN 54-4 standards.
A checklist for ensuring correct installation and configuration for compliance.
To Next Page