Do you have a question about the Bosch PRAESENSA PRA-SCS and is the answer not in the manual?
Essential safety instructions for installation and operation of the PRAESENSA system.
Details key features like IP-infrastructure, power utilization, and availability.
Guidelines for selecting appropriate locations for system components.
Specifies requirements for cabling to ensure safety and reliability.
Details network configurations for optimal PRAESENSA performance.
Methods for calculating the required battery capacity for backup power.
Step-by-step guide to connect the system controller to the network.
Mandatory procedure for connecting the chassis ground screw.
Instructions for connecting the 48 VDC power supply.
Guidance on connecting and managing the backup battery and fuse.
Details connecting 48 VDC outputs to power amplifiers.
Explains network connectivity using shielded CAT5e cables.
Details features intended for PA/VA systems and advanced capabilities.
Instructions for connecting power to the Ethernet switch.
Troubleshooting steps for when the system does not respond.
Diagnosing and resolving device disconnections from the controller.
Procedures for fault analysis and part replacement.
Sequence of actions for replacing system devices with minimal downtime.
Step-by-step guide to replace a defective system controller.
Procedure for replacing a defective amplifier.
Procedure for replacing a defective multifunction power supply.
Procedure for replacing a defective call station.
A checklist for installation and configuration compliance.
Ensuring system architecture meets EN 54 standards.
Compliance regarding installation location and access restrictions.
Compliance for emergency call station setup and configuration.
Compliance requirements for amplifiers and supervision.
Compliance requirements for power supplies with battery backup.
Compliance for VACIE control inputs and outputs.
| Brand | Bosch |
|---|---|
| Model | PRAESENSA PRA-SCS |
| Category | Security System |
| Language | English |











