1 619 929 L03 | (16.3.12) Bosch Power Tools
26 | English
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Leinfelden, 16.03.2012
Assembly
Battery Charging (see figure A)
The battery is supplied partially charged.
To ensure full battery capacity, completely charge the battery (at least 3–
5 hours) before using for the first time.
The Lithium-Ion battery can be charged at any time without reducing its
service life. Interrupting the charging procedure does not damage the bat-
tery.
The “Electronic Cell Protection (ECP)” protects the lithium ion battery
against deep discharging. When the battery is discharged, the power tool
is switched off by a protective circuit.
After the automatic shut-off of the power tool, do
not continue to press the trigger. The battery could
become damaged.
A battery that is new or has not been used for a longer period does not de-
velop its full capacity until after approx. 5 charging/discharging cycles.
When the battery charge-control indicator 2 lights up red during opera-
tion, the battery capacity is below 30% and the battery should be
charged.
– Plug the mains plug of the battery charger into a socket outlet and the
charger plug 8 into the socket 4 on the rear side of the handle.
The battery charge-control indicator 2 indicates the charging progress.
The indicator flashes green during the charge procedure. The battery is
completely charged when the indicator lights up green continuously.
Dr. Egbert Schneider
Senior Vice President
Engineering
Helmut Heinzelmann
Head of Product Certification
PT/ETM9
W
ARN
I
N
G
OBJ_BUCH-1433-002.book Page 26 Friday, March 16, 2012 9:10 AM
To Next Page
Loading...
