English | 27
Bosch Power Tools 1 619 929 L03 | (16.3.12)
Note: The power tool cannot be used during the charge procedure; it is
not defective when inoperative during the charging procedure.
During the charging procedure, the handle of the machine warms up. This
is normal.
Disconnect the battery charger from the mains supply when not using it
for longer periods.
f Protect the battery charger against moisture!
Observe the notes for disposal.
Loading the Magazine (see figure B)
f Use only original Bosch accessories. The precision parts of the pow-
er tool, such as the magazine, the striker and the shot duct, are
matched to Bosch staples. Other manufacturers use other steel quali-
ties and sizes.
– Turn the power tool around.
– Press release buttons 6 and pull out the magazine 10 toward the rear.
– Insert the staple strip 9.
– Insert the magazine 10 again until it engages.
f Do not exert any force when opening, loading and inserting the
magazine.
Battery Charge Indicator
red green Meaning
Battery
Charging
– The battery is being charged
– { The battery is fully charged
Operation
– {
The battery has more than 30%
of its capacity
{ –
The battery has less than 30% of
its capacity and should be
charged
Flashing { Continuous light
OBJ_BUCH-1433-002.book Page 27 Friday, March 16, 2012 9:10 AM
To Next Page
Loading...
