PowerBoost en
13
12.2 Timer
Enables the activation of a timer of 0–99 minutes. This
function can be used independently of the cooking
zones and other settings. It does not automatically
switch off the cooking zones.
Switching on Timer
1.
Press repeatedly until lights up.
2.
Set the desired time in the settings range.
a The time now starts to elapse.
a A signal tone sounds once the time has elapsed.
3.
Press .
a The displays go out and the signal tone stops.
Changing or switching off the Timer
1.
Press repeatedly until lights up.
2.
In the settings area, change the time or set to to
delete the time.
13 PowerBoost
You can use this function to heat up large volumes of
water more quickly than with .
This function is available for all cooking zones,
provided the other cooking zone in the same group is
not in use.
Otherwise, and flash in the display for the selected
cooking zone. is then set automatically without activ-
ating the function.
13.1 Switching on PowerBoost
Requirement:In the combi zone, the PowerBoost func-
tion can only be activated if you are using the two
cooking zones independently of each other.
1.
Select the cooking zone.
2.
Touch . The display lights up.
a The function is switched on.
13.2 Switching off PowerBoost
1.
Select the cooking zone.
2.
Touch . The display goes out and the cooking
zone switches back to the power level.
a The function has been deactivated.
Note:In certain circumstances, this function may
switch itself off automatically in order to protect the
electronic elements inside the hob.
14 Childproof lock
The hob is equipped with a childproof lock. This pre-
vents children from switching on the hob.
14.1 Switching on Childproof lock
Requirement:The hob must be switched off.
▶
Touch and hold for 4 seconds.
a The display beside lights up for 10seconds.
a The hob is locked.
14.2 Switching off Childproof lock
▶
Touch and hold for 4 seconds.
a The lock is released.
14.3 Automatic childproof lock
You can also activate the childproof lock automatically
every time the hob is switched off.
You can find out how to switch the function on and off
in the "Basic settings" section →Page14.
15 Wipe protection
Allows the control panel to be locked for cleaning so
that the settings are not inadvertently adjusted.
The lock has no effect on the main switch.
15.1 Switching on Wipe protection
▶
touch . A signal sounds.
a The control panel remains locked for 35seconds. A
signal tone sounds 5 seconds before the appliance
is switched off.
15.2 Switching off Wipe protection
To switch off the function early:
▶
touch .
a The control panel is unlocked.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
