en Individual safety switch-off
14
16 Individual safety switch-off
The safety function is activated if one cooking zone is
in operation for an extended period and you do not
change any settings. The cooking zone displays
and switches itself off.
The time from 1 to 10 hours depends on the selected
power level.
Press any button to switch on the cooking zone.
17 Basic settings
You can configure the basic settings for your appliance to meet your needs.
17.1 Overview of the basic settings
Display Setting Value
Childproof lock - Manual.
1
Automatic.
– Switched off.
Audible signals – Confirmation and fault signals are switched off.
– Only the fault signal is switched on.
– Only the confirmation signal is switched on.
– All signal tones are switched on
1
.
Energy consumption display
Shows the total energy consumption
between switching the hob on and off in
kWh.
The accuracy of the display depends on vari-
ous factors such as the voltage quality of the
power supply.
– Switched off.
1
– Switched on.
Automatic switch-off of the cooking zones. – switched off.
1
- - minutes until the appliance switches off auto-
matically.
Duration of the timer end signal tone – 10seconds
1
– 30seconds
- 1 minute
Power limitation
Enables the total power of the hob to be lim-
ited, if necessary, based on the conditions of
your electrical installation. The available set-
tings depend on the maximum power of the
hob. You can find precise information on the
rating plate. If the function is active and the
hob has reached the set power limit, is dis-
played and you cannot select a higher power
level.
- Switched off. Maximum power of the hob
1
.
- 1000 W. Lowest power setting.
. - 1500 W.
...
- 3000 W. Recommended for 13 A.
. - 3500 W. Recommended for 16 A.
- 4000 W.
. - 4500 W. Recommended for 20 A.
...
- Maximum power of the hob.
Time for selecting the cooking zone - Unlimited: You can adjust the last selected cooking
zone without having to select it again.
1
– Limited: You can adjust the last selected cooking
zone within 10seconds after selecting it. After this time,
you must select the cooking zone again before adjusting
it.
MoveMode
Allows the default power levels to be
changed.
- Preset power level for the front cooking zone.
. - Preset power level for the rear cooking zone.
Cookware test
You can use this function to test the quality
of the cookware.
- Not suitable.
- Not optimal.
- Suitable.
1
Factory setting
To Next Page
Loading...
Need help?
General
Weight and Dimensions
