Cookware test en
15
Display Setting Value
Set circulating-air mode or air extraction
mode.
- Configure circulating-air mode.
1
- Configure air extraction mode.
Setting automatic start - Switched off.
- Switched on: The ventilation system starts at a power
level in accordance with the relevant power levels for the
cooking zones.
1
Setting the run-on
If your hob is working in air extraction mode,
the ventilation system is switched on at the
power level for approx. 6 minutes.
If your hob is working in circulating-air mode,
the ventilation system is switched on at the
power level for approx. 30 minutes.
The run-on function automatically switches
off after this time.
- Switched off.
- Switched on
1
:
Restoring factory settings - Individual settings
1
.
- Factory settings.
1
Factory setting
17.2 To go to the basic settings
Requirement:The hob must be switched off.
1.
To switch on the hob, touch .
2.
Within the next 10 seconds, press and hold for 4
seconds.
Product information Display
Directory for the technical after-sales
service (TK)
Production number
Production number 1 .
Production number 2 .
a The first four displays provide the product informa-
tion. To call up the individual displays, touch the
control panel.
3.
Touch to access the basic settings.
a and light up as a presetting.
4.
Touch repeatedly until the desired setting ap-
pears.
5.
Select the required setting in the settings area.
6.
Touch and hold for 4seconds.
a The settings are saved.
17.3 Discarding changes to the basic
settings
▶
Touch .
a All changes are discarded and not saved.
18 Cookware test
The quality of the cookware has a major influence on
the speed and the result of the cooking process.
You can use this function to test the quality of the cook-
ware.
Before the test, ensure that the size of the cookware
base corresponds to the size of the cooking zone be-
ing used.
Access is via the basic settings. →Page14
18.1 Carrying out Cookware test
1.
At room temperature, place the cookware with ap-
prox.200ml water in the centre of the cooking zone
that best fits the base of the cookware in terms of
size.
2.
Call up the basic settings and select .
3.
Touch the settings area. The display flashes in
the cooking zones.
a The test is running.
a After 10 seconds, the result appears in the cooking
zone displays.
18.2 Checking the result
You can see what the result means for the quality and
speed of the cooking process in the following table.
Result
The cookware is not suitable for the cooking zone
and therefore does not heat up.
The cookware is taking longer to heat up than ex-
pected and cooking is not progressing as well as
it ought to.
The cookware is heating up correctly and cooking
is progressing well.
To activate this function, touch the settings range.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
