en Cookware test
14
Display Setting Value
Automatic switch-off of the cooking zones. – switched off.
1
- - minutes until the appliance switches off auto-
matically.
Duration of the timer end signal tone – 10seconds
1
– 30seconds
- 1 minute
Power limitation
Enables the total power of the hob to be lim-
ited, if necessary, based on the conditions of
your electrical installation. The available set-
tings depend on the maximum power of the
hob. You can find precise information on the
rating plate. If the function is active and the
hob has reached the set power limit, is dis-
played and you cannot select a higher power
level.
- Switched off. Maximum power of the hob
1
.
- 1000 W. Lowest power setting.
. - 1500 W.
...
- 3000 W. Recommended for 13 A.
. - 3500 W. Recommended for 16 A.
- 4000 W.
. - 4500 W. Recommended for 20 A.
...
- Maximum power of the hob.
Time for selecting the cooking zone - Unlimited: You can adjust the last selected cooking
zone without having to select it again.
1
– Limited: You can adjust the last selected cooking
zone within 10seconds after selecting it. After this time,
you must select the cooking zone again before adjusting
it.
Cookware test
You can use this function to test the quality
of the cookware.
- Not suitable.
- Not optimal.
- Suitable.
Restoring factory settings - Individual settings
1
.
- Factory settings.
1
Factory setting
14.2 To go to the basic settings
Requirement:The hob must be switched off.
1.
To switch on the hob, touch .
2.
Within the next 10 seconds, press and hold for 4
seconds.
Product information Display
Directory for the technical after-sales
service (TK)
Production number
Production number 1 .
Production number 2 .
a The first four displays provide the product informa-
tion. To call up the individual displays, touch the
control panel.
3.
Touch to access the basic settings.
a and light up as a presetting.
4.
Touch repeatedly until the desired setting ap-
pears.
5.
Select the required setting in the settings area.
6.
Touch and hold for 4seconds.
a The settings are saved.
14.3 Discarding changes to the basic
settings
▶
Touch .
a All changes are discarded and not saved.
15 Cookware test
The quality of the cookware has a major influence on
the speed and the result of the cooking process.
You can use this function to test the quality of the cook-
ware.
Before the test, ensure that the size of the cookware
base corresponds to the size of the cooking zone be-
ing used.
Access is via the basic settings. →Page13
15.1 Carrying out Cookware test
As a single cooking zone, the flexible cooking zone is
set in such a way that only the individual item of cook-
ware is checked.
1.
At room temperature, place the cookware with ap-
prox.200ml water in the centre of the cooking zone
that best fits the base of the cookware in terms of
size.
2.
Call up the basic settings and select .
To Next Page
Loading...
Need help?
General