Set up and connect NL
Drinking water connection
3. Check the plug for tightness.
Connect the device to a drinking
water connection.
Install drinking water connection
Note
s When you replace the device,
you can use a new water supply
hose.
1. The necessary steps can be found in
the supplied installation manual.
2. Connect the device to the
drinking water connection using
the enclosed parts.
The "technical data"
→
Page 54
consider.
3. Make sure that the drinking water
connection is not kinked, crushed
or entangled.
Electrical connection
Connect the device to the mains.
Connecting the appliance
electrically Notes
s Observe the "Safety
sing" →
Page 4.
s Only connect the device
on an AC voltage of 220 - 240 V
and 50 Hz or 60 Hz.
s Please note that the
The protection system only works
when the device is supplied with
power.
1. Connect the appliance plug of the
connecting cable to the appliance.
2. Plug the appliance into a socket in
the vicinity of the appliance.
The connection data of the device
can be found on the type plate.
13
To Next Page
Loading...
