NL Troubleshooting
Malfunction Cause Troubleshooting
E:90-01 lights up alternately. Mains voltage is too low. There is no error in the device.
1. Contact an electrician.
2. Have the mains voltage and
electrical installation checked by
the electrician.
Another one appears There is a technical malfunction
error code in the indicator - present.
star.
1. Press .
2. Disconnect the appliance from
the mains or switch off the
fuse.
E:01-00 to E:90-10
3. Wait at least 2 minutes.
4. Plug the appliance into a
mains socket or switch on
the fuse.
5. Switch on the device.
6. If the problem occurs
again:
s Press .
s Close the tap.
s Remove the plug from the
socket.
s Contact the "service
department"
→Page 53 and mention the
error code.
Washing result
Malfunction Cause Troubleshooting
Crockery is not dry. No rinse aid has been
used or the dosage is
set too low.
1. Fill the "rinse agent"
→Page 24 Bee.
2. Set the amount of rinse aid.
→"Amount of rinse aid
set", page 25
The program or program
option has no drying phase or a
drying phase that is too short.
" Select a program with drying,
e.g. Intensive, Strong or ECO
program." → Page 17
The drying result is reduced with
some option buttons, eg
Variospeed.
40
To Next Page
Loading...
