NL Basic settings
B Basic settingsasis settings
B You can set up your device according to your needs.asis settings
Overview of the basic settings
The basic settings depend on the equipment of your appliance.
Basic setting Choise Description
Water hardness Scale with 4 positions Set the water hardness.
→"Setting water softening",
Page 21
Rinse aid dosage Scale with 4 positions Set or switch off the
amount of rinse aid.
→"Amount of rinse aid
set del", page 23
Extra Dry On
from 1
Switch Extra Dry on or off
for each cycle.
For improved drying results, the
temperature is increased during
the final rinse. The running time
may increase slightly.
Remark: Pay attention to
delicate items of crockery.
→"Set extra dry",
Page 32
Factory setting Put back Reset changed settings
to the factory state. Initial
commissioning settings
must be specified.
→"Restore factory setting
ten", Page 33
1 Factory setting (may differ depending on the device type)
Set extra dry
4. Just as often on
the LEDs indicate the desired
value.
press to
1. on to press.
2. To access the device settings,
press . for 3 seconds
If the "LED A" →
Page 15
does
not light up, Extra Dry is switched
off.
If the "LED A" →
Page 15
lights up,
Extra Dry is switched on.
to press.
a flashes in the display .
3. Just as often on
until the display and
run.
to press
clipping
5. To save the settings, press for
approx. 3 seconds.
32
To Next Page
Loading...
