Bosch SGS2ITW11E - Malfunctions

NL Troubleshooting
Malfunction Cause Troubleshooting
Rinse aid refill
indicator lights up.
Rinse aid is missing. 1. Fill the "rinse agent"
→Page 23 Bee.
2. Set the amount of rinse aid.
→"Amount of rinse aid
set", page 23
Rinse aid refill
indicator is not lit.
Water softening is
switched off.
▶ Amount of rinse aid in
set.
Malfunctions
Malfunction Cause Troubleshooting
There will remain after the Sieve system or space below 1.
2.
Clean the "seven" → Page 35.
program water in the
appliance.
the sieve is clogged.
Clean the "drain pump"
→Page 49.
Program has not yet
ended.
▶
Wait for the end of the program
or cancel the program with Reset
off.
▶
→"Abort program",
Page 31
Device cannot be
switched on or operated.
Device functions
have failed.
1. Disconnect the appliance
from the mains or switch off
the fuse.
2.
3.
Wait at least 2 minutes.
Connect the device to
the mains.
4. Switch on the device.
The device does not start. Fuse of the house
installation is not OK.
▶
Check the fuse of the house
installation.
Power cord is not
connected.
1.
2.
Check that the socket is
working.
Check whether the connecting cable is
properly connected to the mains
socket and to the rear of the
appliance.
Appliance door is not
completely closed.
▶
▶
Close the appliance door.
Program starts
automatically.
The program has not
ended.
→"Abort program",
Page 31
Device hangs in a
program or cuts out.
Appliance door is not
completely closed.
▶
Close the appliance door.
46