Set up and connect NL
Drinking water connection
3. Check the plug for tightness.
Connect the device to a drinking
water connection.
Install drinking water connection
Remark
sex When you replace the device,
you can use a new water supply
hose.
1. The necessary steps can be found in
the supplied installation instructions.
2. Connect the device to the drinking
water connection using the
enclosed parts.
The "technical data"
→
Page 55
consider.
3. Make sure that the drinking water
connection is not kinked, crushed
or entangled.
Electrical connection
Connect the device to the mains.
Connecting the appliance electrically
Comments
sex Observe the "Safety
sing" →
Page 4
.
sex Only connect the device
on an AC voltage of 220 - 240 V
and 50 Hz or 60 Hz.
sex Please note that the wa-
The protection system only works
when the device is supplied with
power.
1. Connect the appliance plug of the
connecting cable to the appliance.
2. Plug the appliance into a mains
socket in the vicinity of the
appliance.
The connection data of the device
can be found on the type plate.
13
To Next Page
Loading...
