en
20
– Using a spoon, prise off pump cover
(as illustrated) until it clicks, then grip
the cover by the lug and pull it out
forwards.
– Check inner compartment and remove
any foreign objects.
– Place cover in the original position,
press down and engage.
– Install filters.
Note
If the cover is not engaged properly, this
may cause a programme interruption and
the “Tap 6” display H is indicated.
... when the appliance is
switched on
The appliance does not start.
– The mains fuse has tripped.
– The appliance plug has not been
inserted.
– The appliance door has not been shut
properly.
... on the appliance
Lower spray arm rotates sluggishly.
– Spray arm blocked.
The door is difficult to open. *
– Child-proof lock is activated.
The deactivation instructions
areatthebackintheenvelope.
* depending on model
Cover on the detergent dispenser cannot
be closed.
– Detergent dispenser overfilled or
mechanism blocked by sticky
detergent residue.
Detergent residue in the detergent
dispenser.
– Dispenser was damp when filled.
Refill indicator for salt P and/or rinse-
aid X is not lit.
– Refill indicator/s switched off.
– Adequate salt/rinse-aid available.
Refill indicator for special salt P is lit.
–No salt.
Refill with special salt.
“Tap 6” display is lit
–Tap turned off.
– Water supply interrupted.
– Supply hose kinked.
– Filter in the water supply blocked.
– Switch off the appliance and pull
out the mains plug.
–Turnoff thetap.
To Next Page
Loading...
