en
7
To ensure good washing results, the
dishwasher requires soft water, i.e.
containing low amounts of lime, otherwise
white limescale will be deposited on the
utensils and inner container.
Tap water above 9° Clarke (from set value
•:‹‚) must be softened. The water is
softened with salt (regeneration salt) in the
water softening system of the dishwasher.
The setting and therefore the required
amount of salt depends on the degree of
hardness of your tap water (see table).
Water hardness table
Setting
The amount of salt dispensed can be set
from ‹ to ˆ.
Sal is not required at the set value ‹.
– Find out about the hardness
value of your tap water. Your water
utility company will help you with this.
– Set value can be found in the water
hardness table.
– Close the door.
– Rotate the programme selector 8
from the 12 o’clock position anti-
clockwise by one notch.
–Switchonmain switch ( and hold
down for at least 3 sec.
The current set hardness value is
indicated on the digital display `
and the salt refill indicator P flashes
(set hardness value was set to level …
at the factory).
To change the setting:
– Rotate programme selector 8.
You can select a set value between ‹
and ˆ according
to the hardness of your water.
–Switchoffthemain switch(
The chosen setting has now been
stored.
Water softening system
To Next Page
Loading...
