Bosch SHE43C75N - Troubleshooting

en-us Troubleshooting
26
Troubleshooting
16 Troubleshooting
Troubleshooting
You can eliminate minor issues on your appliance
yourself. Please read the information on eliminating issues
before contacting Customer Service. This may avoid
unnecessary repair costs.
Issue Cause and troubleshooting
Four vertical LED's (i.e. the cycle
duration indicators and the clean
indicator) all light up at the same
time.
Not an appliance error. Garbage disposal is still plugged or the drain hose is kinked.
▶ Check that the garbage disposal plug is removed and that the drain hose is not
kinked.
Not an appliance error. The drain pump cover is loose or a foreign object is blocking
the pump.
▶ Secure the cover of the drain pump so it clicks into place or clean the drain
pump.
Inlet hose is kinked.
▶ Install the supply hose without kinks.
Water supply valve is closed.
1. Open the water supply valve.
2. Terminate the wash cycle.
→ "Terminating the wash cycle", Page19
3. Start a wash cycle.
4. If the problem occurs again:
‒ Contact the customer service.
→ "Customer Service", Page33
Water supply valve is jammed or clogged up.
1. Open the water supply valve.
The flow rate must be at least 10 l/min when the water supply is open.
2. If the problem occurs again:
‒ Contact customer service.
→ "Customer Service", Page33
Power voltage is too low.
There is no problem with the appliance.
1. Call an electrician.
2. Have the power voltage and electrical installation checked by an electrician.