12
H
Fig. 3-3 Fig. 3-4
Operation
SHI 4302/4306 SHU 4302/4306/4312/4316
The SHI or SHU 43** series operates using an electronic Control Unit.
TO OPERATE:
Fig. 3-3.
First depress the On/Off Button until it locks in place.
Fig. 3-4.
Once the On/Off Button is depressed the LED above the previously used cycle will illuminate.
To change the cycle, simply press the desired Cycle Button twice. The LED above that cycle will
then illuminate.
As the program advances the Cycle Progress LED’s will illuminate (wash, rinse / dry). When the
cycle is complete the Clean LED will be illuminated.
TO CANCEL A CYCLE:
Press the Power Scrub Plus and Regular Wash Buttons both in at the same time. The unit will
then drain and the Clean LED will illuminate.
Please note: If the door is opened during the cycle, the On/Off Button will be reset to off andmust
be depressed again to re-active the cycle. The cycle will resume from where it left off.
To Next Page
Loading...
