49
VI.
VI.
Component Access/Replacement
Component Access/Replacement
Heaters &
Heaters &
NTC’s
NTC’s
–
–
Access (4)
Access (4)
To separate base from tank (2):
Disconnect J-box ground wire,
then pull wires out of J-box.
Pull out inlet hose from sump.
Carefully pull base away from
tank and sump.
HINT: Its simpler &
quicker to remove the
two water valve screws
than to remove the
hose clamp.
Pull wires from J-box Pull out sump inlet hose
Carefully pull base away from tank & sump
HINT: Don’t order duplicate parts when ordering parts below --
when these parts are replaced, others are included:
• Heater assy.
-- includes NTC, Hi-Limit, flow switch (& aqua
sensor where applicable).
• NTC
-- includes Hi-Limit.
To Next Page
Loading...