57
VI.
VI.
Component Access/Replacement
Component Access/Replacement
Aqua Sensors
Aqua Sensors
The aqua sensor is located on the rear of the sump. It
can be reached through the left side of the dishwasher
(after the left side panel is removed). Its not necessary
to block up the tank to reach the aqua sensor.
Sump
Base
Tank
HINT: To change out the aqua
sensor, pull off the connector
and pull out the aqua sensor
(toward the rear of the
dishwasher).
HINT: The aqua sensor slides
into slots in the sump. Make
sure the aqua sensor is properly
inserted into the slots.
NOTE: The Apexx Sensotronic 2 aqua sensor # 175340 is
similar to standard aqua sensor # 165279, except it has two
(red & green) soil sensors. They mount the same way, but
are not
interchangeable.
To Next Page
Loading...