Basic settings NL
B Basic settingsasis settings
B You can set up your device according to your needs.asis settings
Overview of the basic settings
The basic settings depend on the equipment of your appliance.
Basic setting Choise Description
Water hardness Scale with 4 positions Set the water hardness.
→"Setting water softening",
Page 22
Rinse aid dosage Scale with 4 positions Set or switch off the
amount of rinse aid.
→"Amount of rinse aid
set del", page 24
Extra Dry On
from 1
Switch Extra Dry on or off
for each cycle.
For improved drying results, the
temperature is increased during
the final rinse. The running time
may increase slightly.
Remark: Pay attention to
delicate items of crockery.
→"Set extra dry",
Page 33
Signal strength Scale with 4 positions Control the signal strength.
→"Audio volume of the signal
set channel", page 34
Factory setting Put back Reset changed settings
to the factory state. Initial
commissioning settings
must be specified.
→"Restore factory setting
ten", Page 34
1 Factory setting (may differ depending on the device type)
3. Just as often on
Set extra dry
to press
1. on to press.
until the display. and
press to
clipping
2. To access the device settings,
press . for 3 seconds
to press.
4. Just as often on
the LEDs indicate the desired
value.
a flashes in the display.
33
To Next Page
Loading...
