EasyManua.ls Logo

Bosch SHV46C13UC/38 User Manual

Bosch SHV46C13UC/38
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
ishwasher installation instructions
English/French/Spanish
f
important Safety instructions
To avoid possible injury or property damage,
OBSERVE ALL WARNINGS AND CAUTIONS.
These instructions are intended for use by
qualified installers only.
The dishwasher must be installed by a qualified
service technician or installer.
In addition to these instructions, the dishwasher
shall be installed to meet all electrical and
plumbing codes and ordinances (both national
and local).
Read these installation instructions completely
and follow them carefully. They will save you time
and effort and help to ensure safety and optimum
dishwasher performance,
if the dishwasher is installed in a location
that experiences freezing temperatures (e.g.,
in a holiday home), you must drain all the
water from the dishwasher's interior. Water
system ruptures that occur as a result of
freezing are NOT COVERED BY WARRANTY.
IMPORTANT
The dishwasher drain hose must be installed
with a portion of it at least 20" (508mm) off the
cabinet floor; otherwise the dishwasher may not
drain properly.
This dishwasher is intended for residential use
only, and should not be used in commercial
food service establishments.
NEW INSTALLATION - If the dishwasher is a
new installation, most of the work must be done
before the dishwasher is moved into place.
REPLACEMENT - If the dishwasher is
replacing another dishwasher, check
the existing dishwasher connections for
compatibility with the new dishwasher, and
replace parts as necessary.
This appliance has been found to be in
compliance with CAN/CSA-C22.2 No. 167/UL
749. It is the responsibility of the owner and the
installer to determine if additional requirements
and standards apply in specific installations.
Inspect the Dishwasher
After unpacking the dishwasher and prior to
installation, thoroughly inspect the dishwasher for
possible freight or cosmetic damage. Report any
damage immediately. Cosmetic defects must be
reported within 30 days of installation.
NOTE: Do not discard any bags or items that
come with the original package until after the entire
installation has been completed.
\ J
1
9000121319REV B ° 01/06
Question and Answer IconNeed help?

Do you have a question about the Bosch SHV46C13UC/38 and is the answer not in the manual?

Bosch SHV46C13UC/38 Specifications

General IconGeneral
BrandBosch
ModelSHV46C13UC/38
TypeBuilt-In
Place Settings14
Energy Star RatedYes
Noise Level44 dBA
Wash Cycles6
Drying SystemCondensation Drying
Control TypeElectronic
Number of Options5
Water Filtration SystemYes
dBA44
Tub MaterialStainless Steel
Delay StartYes
Soil SensorYes
Third RackYes
ColorStainless Steel
Water Consumption2.9 gallons
Width23.5625 inches
Depth22.5625 inches

Summary

Dishwasher Safety Guidelines

Pre-Installation Inspection

Inspect dishwasher for freight or cosmetic damage immediately after unpacking.

Enclosure Preparation and Dimensions

Cabinet Space Requirements

Ensure enclosure is square, with adequate clearance for door opening and unit fit.

Utility Line Pass-Throughs

Create specified openings for electrical, hot water, and drain lines within enclosure.

Electrical Supply Preparation

Dedicated Circuit and Wiring

Connect to a dedicated 120V, 60Hz circuit with a 15A breaker and #14 AWG copper wire.

Plumbing Connections and Requirements

Hot Water Supply Installation

Install shut-off valve, connect hot water line, ensure 120°F water temperature and 15-145 psi pressure.

Dishwasher Drain Hose Routing

Connect drain hose to sink tailpiece, disposer, or air gap, respecting height and length limits.

Dishwasher Unit Preparation

Mounting Bracket Installation

Attach countertop or side mount brackets to the dishwasher base before sliding into enclosure.

Electrical Junction Box Setup

Prepare junction box by removing cover and strain relief plate for electrical hookup.

Custom Door Panel Installation

Accessory Panel Kit Usage

Utilize accessory kits to attach custom panels up to 1/4" thick to specific dishwasher models.

Fully Integrated Door Mounting

Mount custom door panels for fully integrated units using provided templates and tension adjustments.

Dishwasher Securing and Leveling

Mounting Bracket Fastening

Drive mounting screws through brackets into enclosure for top or side mount securing.

Locking Leg Levelers

Lock front leg levelers with enclosed screws after the unit is leveled and secured.

Drain Hose Connectivity

Household Drain Connection Options

Connect drain hose to sink drain, disposer, or air gap according to local requirements.

Hot Water Supply Connection

Braided Hose or Copper Tubing

Connect the hot water supply line using either a braided hose or copper tubing.

Electrical Wiring and Grounding

Proper Grounding Procedure

Ensure dishwasher is properly grounded to a metal wiring system per electrical codes.

Secure Wire Connections

Pass cable through strain relief, secure wires with nuts, and attach strain relief plate to junction box.

Toe Panel Installation Methods

Standard Toe Panel Attachment

Install the toe panel using the provided screws from the dishwasher installation kit.

Base Access and Toe Panel Fitment

Plastic Panel and Insulation Placement

Fit plastic base access panel, insulation strip, and metal toe panel using specific fasteners.

Customer Support and Service

Troubleshooting and Warranty Information

Consult manual for troubleshooting; contact installer or service center with model/serial number.

Related product manuals