16
Interrupt a cycle
1 Open the door, press the [On/Off] button to turn the unit off.
2 To resume the cycle, press the [On/Off] button again and close the door.
Cycle Completion Signal
1 Open the door and press the [On/Off] button.
2 Hold down the “A” button (see page 15) and press [Start] until the
display indicates “d:00”. Release both buttons.
3 Press the “A” button until the display shows “b:02”.
4 Press the “C” button to increase or decrease the tone “b:00” = OFF
and “b:03” = LOUDEST
5 Press [Start] to save setting and close the door.
Delay Start
You can delay the start of the cycle in one hour increments up to 24 hours.
1 Open the door and press the [On/Off] button and select desired cycle.
2 Press the [Delay] button until the displayed time corresponds with
your requirements.
h:01 = 1 hour delay h:24 = 24 hour delay
3 Press [Start] to activate delay start. Wash cycle will begin after set time.
To cancel delay start:
1 Press the [Delay] button until “h:00” is indicated on the digital display.
2 Press [Start] to save setting and close the door.
Intensive Drying
The final rinse uses a higher temperature which improves the drying
results. The running time may increase slightly.
To turn intensive drying on:
1 Open the door and press the [On/Off] button.
2 Hold down the “A” button (see page 15) and press [Start] until the
display indicates “d:00”. Release both buttons.
3 Press the “C” button to turn intensive drying on or off. “d:01” = ON
and “d:00” = OFF
4 Press [Start] to save setting and close the door.
InfoLight®
An LED illuminates the floor to indicate the unit is running. If the appli-
ance is installed at eye-level, the LED is not visible.
To change the setting:
1 Open the door and press the [On/Off] button.
2 Hold down the “A” button and press [Start] until the display indi-
cates “d:00”. Release both buttons.
3 Press the “A” button until the display shows “1:01”.
4 Press the “C” button to switch between “1:01” = ON and “1:00” =
OFF and press [Start] to save. Close the door.
To Next Page
Loading...
