16
NOTE: For models with hidden controls, the door must be opened
before changing settings and closed after changing settings.
NOTICE: Use caution when opening door during a running cycle. Hot
water may splash out. Open door slowly.
Start the dishwasher
1 Press the [On/Off] button.
2 Select a cycle (Auto cycle is preselected) and desired options.
3 Press [Start] and the cycle will begin.
Cancel a cycle
1 Press and hold the [Start] button for approximately 3 seconds until
the display reads “0:01”.
2 Wait about 1 minute while the dishwasher drains and the display
reads “0:00”.
3 Press the [On/Off] button. You may now power the dishwasher
back on and begin new cycle if desired.
Interrupt a cycle
1 Press the [On/Off] button to turn the unit off.
2 To resume the cycle, press the [On/Off] button again.
Cycle Completion Signal
1 Open the door and press the [On/Off] button.
2 Hold down the “A” button (see page 15) and press [Start] until the
display indicates “d:00”. Release both buttons.
3 Press the “A” button until the display shows “b:02”.
4 Press the “C” button to increase or decrease the tone “b:00” = OFF
and “b:03” = LOUDEST
5 Press [Start] to save setting and close the door.
Delay Start
You can delay the start of the cycle in one hour increments up to 24 hours.
1 Press the [On/Off] button and select desired cycle.
2 Press the [Delay] button until the displayed time corresponds with
your requirements.
h:01 = 1 hour delay
h:24 = 24 hour delay
3 Press [Start] to activate delay start. Wash cycle will begin after set
time.
To cancel delay start:
1 Press the [Delay] button until “h:00” is indicated on the digital dis-
play.
2 Press [Start] to save setting.
To Next Page
Loading...
