Tools and Materials Needed
TOOLS NEEDED
Hammer
Tape Measure
WireCutter
Hole Saw
Slot Screwdriver
Wire Stripper
Pipe Wrench Adjustable Wrench
Phillips Screwdriver
Torx Screwdriver
Level
MATERIALS NEEDED
(Additional materials may be required to comply with local codes.)
_ Electrical Cable- Minimum #14 2 1 insulated
Supply AWG, conductor, ground,
copper
_/._-._ conductors rated 75°C or higher. ,,
_A Hot Water Supply Line - Minimum 3/80.D. copper tubing or metal braided dishwasher
_ supply line.
:St:t Shut-off valve and fittings appropriate for hot water supply line (copper tubing/
compression fitting, or braided hose).
90° elbow with 3/8" N.P.T. male threads on one leg, and sized to fit your water supply
line (copper tubing/compression fitting, or braided hose) on the other leg.
.!/ Teflon tape or other pipe thread compound to seal plumbing connections.
UL listed conduit connector or strain relief.
2
To Next Page
Loading...
Need help?
General
